Passenger Door Handle

[Lex Luthor]

If you look at the external handle when it's pulled open, you can see the end of the cable - is ther a way of retensioning the cable from the outside of the car?

Just above the door lock, covered by the door seal, is a torx-T20 setscrew that secures the blanking cover at the rear of the handle.
Slacken it off, remove the cover, and you can adjust the cable by repositioing the cable end.

[Col]

Just above the door lock, covered by the door seal, is a torx-T20 setscrew that secures the blanking cover at the rear of the handle.
Slacken it off, remove the cover, and you can adjust the cable by repositioing the cable end.

As Mr Luther has said but in addition...

The adjustment is via the cable end being a square plastic 'nipple' with serated edges, these edges locate in a corresponding square receptical also with serations. Adjustment is via moving the cable serated 'nipple' out so that it grabs the next set of serations.

All done once the lock barrel is out.

[neilc]

Thanks Big Col (and you too Lex)
I'll give it a try on the weekend