Pertronix Ignitor II, for use with Bosch 009 or 050 distributors.

[esky365]

Hi

I recently purchased an unused Pertronix Ignitor II, for use with Bosch 009 or 050 distributors.

Unfortunately it came without instructions, can anyone help?
thanks

esky

[caz112]

the little black bush pushes over the distributor center [it is a very tight fit]
the bit with the wires replaces the points.
you then feed the two wires through the side of the distributor and remove the condensor
the red wire must go on the + [15 ] terminal the black wire to the _ [1] terminal on the coil
do not conect the wrong way around it will blow the unit !!!
set the gap using the slip of plastic that is in the kit and check the timing.
dead easy realy