B6 Passat 2006 torque wrench settings

[freebird69]

Does anyone know any of the following torque settings for a 2006 B6 Passat?
main front hub bolt
inner CV joint flange bolts
front brake calliper pins
front brake calliper bracket bolts
bottom ball joint nuts
upper tie rod nut

[martin1810]

Main hub bolt. Hex bolt...200Nm + 180 degree 12 point bolt...70Nm + 90 degree..Use new bolt.
CV joint/gearbox bolts M8 spline...40Nm (10Nm at a time) M10 spline 70 Nm (ditto)
Bottom ball joint nuts....60Nm
Caliper Pin....30 Nm
Caliper bracket....190 Nm
Tie rod ? Do you mean track rod ? which is 100Nm ( tighten loosen 180 degree retighten)

[freebird69]

@martin1810 : Thanks for all the torque settings

Regarding the main hub bolt which is a 22mm (I think) hex on mine ... I believe that this should *not* be reused but when checking with a main dealer parts dept, they only had the 12 point star bolt listed. Does anyone know if the 2x bolts have the same thread? i.e. can the be interchanged?