allroad suspension

[chris.d]

hi all have another a6 c7 allroad suspension issue ..again!!
i changed all 4 wheels ...and forgot to put suspension in wheel change mode.now have a "suspension fault" on dash .
garage put it on computer .and came up with code c1031f1
"level control pressure sensor residual pressure for lowering rear suspension too low" ? suspension goes up good but does not want to go all the way down.but seems to correct itself when i restart car and drive. any ideas what i might have damaged ? could it be a level sensor maybee ?

[Crasher]

I had this on an type 4H A8 a few weeks ago, the rear suspension refused to go down, even with the air lines to the valve block disconnected, it had come to a motor trade friend of mine from a car trader friend of his via an auction. The only way we could get it to come down was to drill a hole in each air bag so they could be removed and replaced with two new struts at nearly £2k each... At least 4G air bags can be replaced.

[chris.d]

hi all have another a6 c7 allroad suspension issue ..again!!
i changed all 4 wheels ...and forgot to put suspension in wheel change mode.now have a "suspension fault" on dash .
garage put it on computer .and came up with code c1031f1
"level control pressure sensor residual pressure for lowering rear suspension too low" ? suspension goes up good but does not want to go all the way down.but seems to correct itself when i restart car and drive. any ideas what i might have damaged ? could it be a level sensor maybee ?

also if i change both rear sensors do i need to do any other adjustments or is it just a case of replacing them

[Crasher]

You must do the basic settings

[chris.d]

hi crasher thanks
do you mean just clear faults after replacing sensors ?

[Crasher]

The four corner heights have to be entered into the level control unit

[Cruiser1]

Hi all, newbie here...
Can anyone tell me the ride heights on all four wheels, have a A6 C6 allroad 2011, recently replaced N/S front airbag, had the calibration done but the O/F front looks too high in all of the modes
Thanks
Chris