HELP - AKE engine injector #3 with needle lift sensor needed

[Robnelson76]

Hi Folks,

I have a 2002 A6 2.5tdi and after doing the Cambelt I've discovered that my needle lift sensor on injector #3 has given up the ghost and I can't adjust the timing without getting it sorted.

Audi want over 25% of the car value for one, does anyone have a spare I can buy?

Please help..... Please......

[Doctle Odd]

VW AUDI 2.5 TDI V6 NEEDLE LIFT INJECTOR 059130202F | eBay

[ametlib]

Hi, try to adjust the pump so the readings in measuring blocks- cold start valve/ advance solenoid is around 95 % at idle ( engine temp over 85 degrees) The ECU uses a sensor in the Injection pump and the Engine speed sensor to figure this out,
so you might get lucky...

[jubbly]

ebay is the best bet.

[Robnelson76]

Does anyone have any info on how easy it is to change Injector # 3? Now I have a shiny new one I'm thinking of swapping it myself.....?

Thanks.

Rob

[jubbly]

It's fairly tricky to do but you only need to get the left side rocker cover off and you can see the injector to get it off. you need to strip a fair bit down though.

[frankc]

Good guide here

http://www.audi-sport.net/vb/a4-a4-c...placement.html

I used this when swapping number 5 injector on my BDH. Before you start make sure you have a new rocker cover gasket, copper sealing washer for the injector (dealer, 51p) and new leak-off banjo copper sealing washers (21p, dealer). I wish I'd done my rocker cover gasket at the same time as it'll never seal again properly.

Frank

[taggart]

Hi
I am looking for a replacement needle lift sensor part no. 059130202F for my Audi allroad 2.5 tdi car , 2004 model. can anyone help me out with this. thanks

[jubbly]

Hi
I am looking for a replacement needle lift sensor part no. 059130202F for my Audi allroad 2.5 tdi car , 2004 model. can anyone help me out with this. thanks

I'd start on fleabay.