Vw passat B6 handbreak issues

[Bigbull]

I all I have a vw passat B6 I have been having issues with the eletric handbreak sometimes it says it failed then if I just wait a couple of mins and try again it will engage and go on can anyone suggest what could be up

[benny1982]

Change the switch out $10 on ebay ,happens with a lot of b6's

Sent from my SM-N9005 using Tapatalk

[RichardSEL]

As above from Oz. Replacement switch is the "C" version ("C" on the end of the part #)
Although not as cheap as AUS$10 over here

When your EPB's operating do you hear both NS and OS motors run?

[Bigbull]

Hi when button has been pressed you hear the motors run but like what happened last night it said handbreak failure

[DMitch16]

Does the button light come on? If not there will be a Function Lamp in Control Head fault stored which basically means the button diode / bulb has blown. Replace button as per previous advice.

Getting a fault code scan with VCDS / VagCom will provide more detail.

[Bigbull]

The light comes on but it says on the info screen that handbreak failure see handbook but sent it back where we bought it from and there could find anything with the codes so they reset the full lot and sent it back and it happened again last night but after a couple of seconds it come on with out a problem

[DMitch16]

If there is a Parking Brake fault light on your dashboard there will be a fault code. The place where you bought the car may not have the diagnostic software to "see" all fault codes stored and are only able to do a reset (a clear all codes type tool). The car should be scanned for faults with VCDS (VagCom) or anything capable of reporting fault codes like VAS from all modules installed on the car (VAS is the dealer diagnostic tool). When referring to an EPB system "Handbrake Failure" could mean lots of things as the system is more complex than a mechanical lever handbrake and such a message will not necessarily that your hand brake has failed but that one of its components is faulty.