Jetta Cruise Control Activated - MFD Stopped Working

[D7LCD]

Hello All,

I have a quick question, I followed the useful guides and information on this site with regards to retrofitting cruise control but have come across a problem where I now have cruise control but my wiper stalk no longer controls the MFD. I cant change any of the information displayed.


I have a late 2006 VW Jetta TDI Sport, it has the midline MFD. Steering wheel controller PN: 1K0 953 549 AP and the diagnostic wire was already present. I then purchased a stalk PN: 1K0 953 513 G9B9
Fitted it and coded the Engine ECU with code 11463.
Unfortunately my VCDS Lite and basic cable would not talk to the steering wheel controller so another member "a4audio" who lives a few minuets away from me very kindly used his VCDS to change my steering wheel code from 000011 to 000021 following my instruction.
The end result is the cruise control works perfectly but I can no longer control my MFD. I believe I should have coded 000041 does anyone else agree with this?




For reference the steering wheel coding is as follows: (I have Bold'd my chosen selection)

0?xxxxx: Vehicle Type
0 = Normal
1 = Special Purpose (e.g Taxi)
0x?xxxx: Transmission
0 = Manual Transmission
1 = Automatic Transmission
0xx?xxx: Steering Wheel
0 = Steering Wheel without Multifunction
1 = 3-Spoke Steering Wheel without Multifunction
2 = 3/4-Spoke Steering Wheel with Multifunction without Cruise & Voice Control
3 = 3/4-Spoke Steering Wheel with Multifunction with Cruise & Voice Control
0xxx?xx: Additional Equipment
0 = Manual
1 = Tiptronic (Shift Paddels)
0xxxx?x: Board Computer / Cruise Control System (CCS)
0 = w/o Board Computer and w/o Cruise Control System (CCS)
1 = with Board Computer and w/o Cruise Control System (CCS)
2 = w/o Board Computer and with Cruise Control System (CCS)
4 = with Board Computer and with Cruise Control System (CCS)
0xxxxx?: Rear Wiper
1 = Rear Wiper not installed
2 = Rear Wiper installed


Thanks in advance for any advice.

Luke

[D7LCD]

We changed the code (Thanks a4audio) from 000021 to 000041 and it all works perfectly.