My Haynes manual gives a figure of 90Nm+90 for the crankshaft pulley bolt. Im about to replace cambelts etc. so ordered a new bolt (part number N91048701) which is a 21mm 12pt with a dimpled head rather than the original 19mm 12pt flat head (now obsolete).

I've been googling around trying to find accurate torque settings for this new type of bolt, and found this:-

Tightening procedure for poly V-belt pulley securing bolt

which states 150Nm+180. I'm a bit worried that this may be a typo, so can anyone with access to the official VW data confirm the setting?