Hey everyone,

I have looked and looked everywhere but I am unable to find the information I require.

I had the dreaded 'NO OIL PRESSURE' come up on my car a few weeks ago on my BRE engine.

I have stripped that car down and found the issue to be with the worn hex drive in the balance assembly drive shaft. This balance shaft assembly was removed from the car and stripped down so that I could remove the faulty shaft and get it sent away for repair.

The newly repaired shaft arrived yesterday and so I thoroughly cleaned, oiled and reassembled the balance drive assembly and this is where my problem now is. I can't, for the life of me, find any torque setting for the bolts which hold the balance assembly together. I have got all of the information and torque values to put the balance assembly back onto the car but nothing to assemble the actual assembly itself.

If anyone could assist with this information I would be VERY greatfull as I want to get the car back on the road tomorrow and this is now holding me up. I don't want to just do them 'tight' as I don't want this to fail again in the future.

Thank you in advance guys and I look forward to any help one can give.

Craig