2010 Polo Remote Central Locking (Replacement/Installation)

[Anthonygee68]

Hi Roger, I hope you don't mind me jumping on this thread? I've just fitted an rclick unit to my 2011 6r which is working fine but I want to wire the windows to close, did you do this and if so, could you let me know which wire I need to connect on the door pillar? Thanks in advance bud. Ant

[Woo85]

Hi buddy

So my keyfobs for the rclick have stopped working.
I’ve tried everything to get them working.

Any ideas what could be wrong?

[funkyfin2000]

Hi buddy

So my keyfobs for the rclick have stopped working.
I’ve tried everything to get them working.

Any ideas what could be wrong?

Same issue! One stopped working and eventually the next one too! This is what RCLICK said to me....

Remote setup – coding – OF NEW REMOTES
For Remote Central Lock and Remote Keyless System:
Follow the below steps to add or delete a new transmitter.

1. On the side of the control unit there is a tiny push switch
2. Press the switch for couple of seconds *before pressing the switch - make sure the unit power is connected
3. Keep the switch pressed.
4. Press the lock key on one of the remotes and the unlock key for the other remotes. This step has to be done straight after step 2!.
You must do this for all remotes!!! As it cancels any existing remotes… This is for security reason!
5. That’s it, wait few seconds and then test both remotes!

If the remote did not get any new codes within 10 seconds, the system will exit learning mode automatically.
Note: once entered into code learning mode, all previously learned remotes will be cleared.