2001 (51) Audi A4 B6 Avant 1.9TDI 130 AWX - No low rpm power (stalls, judders, hesitates), idles fine

[zollaf]

explore the vcds section and you may find a local member with vcds who can help you.

[wutr]

Right, I've looked on the VCDS Users MAP and it's not too bad. 30 minutes away or so, but bear in mind that I can't really drive my car anywhere in the hills.

I've started a thread as to which cable would work with my car and VCDS Lite. I could not find too much info on the forums so I hope someone found one that works:
VCDS Lite cable experience - Audi A4 B6 (Dec 2001, 1.9tdi 130 AWX)

[nevo]

Here's something you could try first,the egr actuator you're refering to,is it the one with the diaphram and small black rod???,if so remove the boost pipe and check its operation by removing the 1/4" vac pipe and suck on it with some other pipe,also detach the rod and operate manually see if it operates smoothly and returns to the fully open position,just something to try before you get a code scan.

[zollaf]

i had a golf with that rod snapped so the valve was closing. that lost rather a lot of power until 3 small cable ties fixed it.

[wutr]

RE: the manifold flap actuator rod. I remember the rod / actuator moving after shutting the engine down. It looked like it was functioning properly.


Today I finally had time to have another look at the problem, and the diagnostics cable I ordered (see my other thread) arrived as well. I plugged it in and fired up VCDS Lite. The Engine module said: 0 fault codes. I ran the auto test (it tries Engine + Brakes before telling you off for not registering) and again: 0 fault codes. Since the last I knew was that the engine had the problem I described in the opening post, I thought I missed out on something with the VCDS config.

I started the engine to see if that would produce any faults. After a minute or so on idle RPM I revved it up to about 2000rpm like I did a couple days earlier. However, no hesitation, no juddering, no nothing. Smooth as it used to be and again 0 fault codes.

Took it for a test drive, filled it up with diesel and floored it in 3rd and 4th gear after about 30 minutes driving. At first there was some smoke, but the second time I couldn't see any in the rearview mirror.

The only thing I could think of that explains why it sorted itself out is that there is a dodgy connection / connector somewhere which was influenced by the dampness a few days ago. It has had no rain since. Question is: which one? (if it is a connection at all)

[suman666]

I have an Audi A4 TDI B6 2001 with AWX. Which also has powerloss problem in Low rev. This car is low on power most of the time. Specially when it rains or I goto a automatic car wash. Say if I start the car I feel the car produces only about 20% of the engine power. Nothing happens if I floor the accelerator or half. The car moves slowly until it hits 2500 rpm and then it shoots like a rocket and lot of black smoke comes out. It is frustrating when there is traffic jam.
I took it to the garage, they cleared the plenum chamber for any blockage, tested the vacuum lines with smoke, checked EGR and MAF found nothing wrong. I ran VCDS diagnostic at-least 20 times over last year. No fault. But still the problem starts if I goto a automatic car wash. I don't know what to do and how to find out the fault.
As your problem seems very similar to mine, if you find any solution please share with us. Thanks

[ajrayner]

I reckon a bucket and sponge will fix it

Not all faults will throw a fault code so you need to do some logs. This site has some excellent info