help with vcds fault codes

[chrismk5]

thanks again, tryed disconecting my maf today and it was worse went lummpy and wouldn`t rev past 2000rpm and put the epc light on i never took it a run tho, i noticed that the inelt could be doing with a good clean while doing this, think al take the throttle body off tomorrow and have a nosey,im gonny try get it back on vag-com and scan it separate

[rstmg]

Found this, it's not directly your problem but same code & a scan of just the engine control module produced a code

ESP light on 01314 and 17656 codes

so assume scanning your ECM will also do this. Note; it may flag up a code because you ran the engine with the MAF disconnected yesterday so may pay to scan, delete any code (after noting what it said) then re-scanning to see any "permenant" code.

Sorry I can't be of much more help, if you don't get any joy from this then it might pay you to start another thread in the specific forum for your car rather than the VCDS one?