hi
just putting in a rebuilt gearbox on my 2.0 sdi and noticed the rear lower gearbox rubber engine mount, both top and bottom have partial splits in them, the ones that sit in the subframe. How do you do the job, my haynes manual is useless. The bolt doesn't want to come out, looks like a real pain? Can it be done without dropping the subframe? I presume its getting the bolt out that is the problem, I would think I could get the mounting bushes out with the subframe in situ if the bolt was out. I've seen a febi single bush advertised on a french website that replaces the two original bushes, might be easier to get in than two. I would welcome and advice from people who have experience doing this job. Thanks