Printable View
I’m really struggling hard to find a bumper for my blue ld5q colour code golf
Don’t really want one sprayed
Anyway I’ve found one but it’s a 170 bhp and it has the exhaust tips and the hole cut for the exhausts
Will the end cans fit my 140bhp bmm engine
Many thanks
Sent from my iPhone using Tapatalk
I’ve seen another car but the code in the boot doesn’t show a colour code any info on here I’m missing https://uploads.tapatalk-cdn.com/202...71431720fa.jpg
https://uploads.tapatalk-cdn.com/202...ea248c8404.jpg
This is the car above for breaking and this is mine
https://uploads.tapatalk-cdn.com/202...e8fbe962c6.jpg
Sent from my iPhone using Tapatalk
That sticker is on the actual rear boot mat. 1K6863463F is "Luggage compartment floor covering", and Anthracite (translated) is its colour :). Is it colour or fitment from the YH54 car that you're trying to check? If you ask Crasher nicely I think he can look up the colour code from the reg.
Both cars are Shadow Blue LD5Q
Thank you very much been looking for one for ages needs a polish mind [emoji3]
Sent from my iPhone using Tapatalk
Does anyone know if the 170 and 140 exhausts are changable
The bumper I looked at was no good and the 170bhp has a hole cut for the exhaust
Sent from my iPhone using Tapatalk
Why don’t you just get yours repainted rather than messing around?
You mean you want to change your exhaust? Or will the bumper parts change to fit whatever exhaust you have?Quote:
Originally Posted by monty9120
The top part of the 2007 bumper (blue in your pic) is 1K6807417 with suffixes for parking sensor holes, etc. That should fit across 2004 and 2007 on all variants.
The lower part (black on your pic) depending on standard, GT, GTI, etc (then tow-bar or not) is 1K6807521A, 1K6807521C, some others. So all a bit difficult to tell really on that part, but you can see the basic incompatibility if you look for the A and C suffix online - A has a left-side exhaust notch while C has space for a centre insert for the twin exhaust: 1K6807568.
Which part are you trying to replace?
I just want to replace the back box from a 170 bmn To a 140 bmm engine
I have sourced a rear bumper but it has cut outs on the left side for the twin chrome pipes
My bottom part of my bumper has been in a bump so don’t really want to reuse it if possible otherwise I would switch them across
Sent from my iPhone using Tapatalk
Looking at various diagrams I don't think you'll be able to easily get a mechanical join up, and would be cautious of any effect to back pressure, turbo action and sensors, etc.
Is this is the sort of rear bumper you're trying to fit?
https://upload.wikimedia.org/wikiped...r_20080709.jpg?