help with error address 46

[aristidis]

can any one give me any ideas on the below problem ?it happen after i disconnect the can bus terminator plug and try to start the car....

Address 46: Central Conv. Labels: 8K0-907-064-46.clb
Control Module Part Number: 8K0 907 064 BQ HW: 8K0 907 064 BQ
Component and/or Version: BCM2 1.1 H90 0247
Software Coding: 01000E20203904150330020000000000
Work Shop Code: WSC 00003 207 91381
1 Fault Found:
01321 - Control Module for Airbags (J234)
004 - No Signal/Communication
Freeze Frame:
Fault Status: 01100100
Fault Priority: 6
Fault Frequency: 1
Reset counter: 7
Mileage: 26599 km
Time Indication: 0
Date: 2010.02.19
Time: 19:07:45

[Hex69]

can any one give me any ideas on the below problem ?it happen after i disconnect the can bus terminator plug and try to start the car....

Address 46: Central Conv. Labels: 8K0-907-064-46.clb
Control Module Part Number: 8K0 907 064 BQ HW: 8K0 907 064 BQ
Component and/or Version: BCM2 1.1 H90 0247
Software Coding: 01000E20203904150330020000000000
Work Shop Code: WSC 00003 207 91381
1 Fault Found:
01321 - Control Module for Airbags (J234)
004 - No Signal/Communication
Freeze Frame:
Fault Status: 01100100
Fault Priority: 6
Fault Frequency: 1
Reset counter: 7
Mileage: 26599 km
Time Indication: 0
Date: 2010.02.19
Time: 19:07:45

What car do you have, model engine etc, the more information you can give the better.

[aristidis]

What car do you have, model engine etc, the more information you can give the better.
A4 allroad 2009 mmi3g ,2.0tfsi.
i did a retrofit of a reverse camera and when i stiped the can bus main diagnostic plug to fit the can bus wires from the controler ,all was good but the fault came up.try to clear it but is on all times.i rechecked all wiring ,no luck.i even removed my retrofit cables and still no luck.However while i was doing the retro and had the can bus plug terminator off i start the ignition,the car didnt start and then i remembered to plug in the terminator :).i have no other faults on my car and the reverse camera works ,there is no warning light on my air bags and it picks up the controlers and the air bags with no fault....
any ideas?

[martin1810]

I don't think you have a fault. I think it has recorded the fact that you turned on the ignition with the plug out. So it is a memory of a fault, not an actual fault. If airbag communication was still missing you would have an error code now.

[aristidis]

I don't think you have a fault. I think it has recorded the fact that you turned on the ignition with the plug out. So it is a memory of a fault, not an actual fault. If airbag communication was still missing you would have an error code now.
IT makes sence...but why i cannot erase it with vag com?well it comes back after i erase it.
thanks
ARI

[aristidis]

hello thanks for your interest, my question is any fault should be able to get erased if it is not there anymore? So if the case with the memory was the issue then why it comes back on after i erase it with vag com ?
thanks ARI