PDA

View Full Version : Help please, Airbag code.



Jay2o
15-12-2009, 02:36 PM
Hi all,
Am using the shareware version 409.1.
and had this code come through:

00532-supply voltage B+
06-10-signal to high-Intermitant.

The airbag light is on constantly and has been since I bought it, but only
noticed now, as the guy put black tape over it to hide it, and has now
fallen off :Blush2:

Its a 1995 1.4 golf,
Does any one know what the fault code be, as all other codes shown up in
searches shows that the voltage is too low.

Should I clear it and see what happens?

Any help/advice would be much apreciated.

kite
15-12-2009, 02:40 PM
From the ross tech wiki
00532 - Supply Voltage B+: Signal too Low
Possible Causes
Wiring/Connectors from/to Control Module faulty
Power Supply (Battery/Generator) faulty
Possible Solutions
Check/Repair Wiring/Connectors from/to Control Module
Check Power Supply (Battery/Generator)
Special Notes
When found in an individual control module, it's most likely a local source (e.g. wiring/connectors).
When found in multiple control modules at the same time, it's most likely a common source (e.g. ground spot, battery, generator).
Intermittent codes are often stored during low outside temperature when the battery capacity goes down and may be ignored.
Common with 16946/P0562/001378 - System Voltage: Too Low stored in other control modules.

Crasher
15-12-2009, 02:41 PM
Clear the code, it should go away.

Jay2o
15-12-2009, 02:59 PM
Thanks guys, will give it a wirl.

Jay2o
17-12-2009, 02:49 PM
Well cleared code and aint come on for a while, looks like it worked.

Thanks again both for your help.