S-line avant exhaust options

[Swifty09]

I have a 55 plate S-line avant 2.tdi 140 bhp,which is the best aftermarket exhaust to get as I see Milltek only list one for the 170 bhp model which has a silencer at each rear corner and wont fit mine as I only have one silncer on the passenger side rear.
I would prefer stainless steel if possible.
Where is the cheapest place to buy
thanks

[bez101]

I have a 55 plate S-line avant 2.tdi 140 bhp,which is the best aftermarket exhaust to get as I see Milltek only list one for the 170 bhp model which has a silencer at each rear corner and wont fit mine as I only have one silncer on the passenger side rear.
I would prefer stainless steel if possible.
Where is the cheapest place to buy
thanks
milltek are 1 of the best if not the best ring them they will sort you the correct 1 for your car

[Swifty09]

hi
thanks for the reply,I have already emailed Milltek and their answer they sent me is below-

Many thanks for your email.

Unfortunately at this moment in time we don't have any products listed for the 140TDI Audi A4.

It may be possible that one of our other B7 systems will be compatible but without seeing technical data or a vehicle for development we cannot commit 100%.

Regards

Leigh Ravey

[fancy a cuppa]

Hi Swifty09

I agree with you on this one, i also contacted Milltek & got the same response. :confused:

I have a B7 S-Line Saloon 2.0 TDI ?

Anyone else a bit stuck, i would like one of these systems also....... mmmmm. :Blush:

[bez101]

Hi Swifty09

I agree with you on this one, i also contacted Milltek & got the same response. :confused:

I have a B7 S-Line Saloon 2.0 TDI ?

Anyone else a bit stuck, i would like one of these systems also....... mmmmm. :Blush:
swifts in sheffield did me 1 for the same car u have they keep milltek in stock so just matched me 1 up

[Swifty09]

I have now been told that the exhaust from a 170bhp model will fit,,All I need to do is fit a 170bhp model rear valance to the bottom of the bumper,get a new heatshield and a drivers side exhaust hanger.

[McNeill]

I have now been told that the exhaust from a 170bhp model will fit,,All I need to do is fit a 170bhp model rear valance to the bottom of the bumper,get a new heatshield and a drivers side exhaust hanger.

Correct. Ive been meaning to do this for a while, but the missus will go ballistic if i splash out the cash when im supposed to be saving for our wedding. :aargh4: