PDA

View Full Version : Question Couple Q about Central Locking



nasonovartem
12-08-2008, 06:59 PM
1 What is correct procedure to programm 2 button fob?

2 If You changing factory fitted stereo to aftermarket one is there any wires interconnected with cl module? If yes what has to be done with wires?

3 Coding for CL module? (any other numbers except ross tech vikis page)?

a4 b5 1.8 se first reg in uk in 07.1998, cl 8lo......g

Thank You

olds_kool
12-08-2008, 07:15 PM
remote fob coding

1. insert key into ignition and turn on (turn one notch do not start car) does not matter what type of key as long as it is coded to the immobiliser i.e capable of starting car

2. insert second key (fob type) into drivers door lock and turn to lock car

3. press unlock button on fob once (indicator should flash), wait six seconds press unlock button again, car will unlock, remove key

4. open door and remove key from ignition, close door and press lock/unlock buttons on fob, car should now lock/unlock


to code a second fob

follow steps 1 + 2 using second fob to be coded to lock drivers door then press unlock button twice, wait six seconds and press unlock again, then go to step 4

up to four keys can be coded to the pump, for third key you would press unlock 3 times, wait 6 seconds etc.... if you code key two but only press once it would replace key one as you would be storing it in position one

nasonovartem
12-08-2008, 09:06 PM
I did all that and all went fine(according intruction).
I took out key from egnition and after that C/L not responding to Fob.


remote fob coding

1. insert key into ignition and turn on (turn one notch do not start car) does not matter what type of key as long as it is coded to the immobiliser i.e capable of starting car

2. insert second key (fob type) into drivers door lock and turn to lock car

3. press unlock button on fob once (indicator should flash), wait six seconds press unlock button again, car will unlock, remove key

4. open door and remove key from ignition, close door and press lock/unlock buttons on fob, car should now lock/unlock


to code a second fob

follow steps 1 + 2 using second fob to be coded to lock drivers door then press unlock button twice, wait six seconds and press unlock again, then go to step 4

up to four keys can be coded to the pump, for third key you would press unlock 3 times, wait 6 seconds etc.... if you code key two but only press once it would replace key one as you would be storing it in position one

olds_kool
12-08-2008, 09:31 PM
8l0 'g' pump in an a4, standard coding would be 13130 if i remember correctly, provided remote locking is activated instructions should work

i beleive it can be done through vag-com but not sure of procedure

nasonovartem
12-08-2008, 09:50 PM
Yes i have 13130 coding for c/l.


8l0 'g' pump in an a4, standard coding would be 13130 if i remember correctly, provided remote locking is activated instructions should work

i beleive it can be done through vag-com but not sure of procedure