ABS module coding HELP

[RaLuci]

Hi guys,

I tried to replace a EPB module and it didn't work as planned.
I coded the ABS and code was accepted, coded the EPB module code was accepted but when I go into testing Error everywhere. group 063 error, group 061 error...
Could someone kindly provide some knowledge about what I'm missing. And also if you don't mind the ABS login Code and the soft code number etc.. to double check that I imputed the right codes.
Below you have some info about the car.

vin: WVWZZZ3CZ8E108594
Address 03: ABS Brakes Labels: 3C0-614-109-0C4.clb
Part No SW: 3C0 614 109 D HW: 3C0 614 109 D
Component: J104 C4 440 V2 0003
Revision: --020--- Serial number: 00000776413416
Coding: 0001294
Shop#: WCS 05311 000 00000
VCID: 1F4A7B53CEAE7BC644-804A



Best regards35818

[DieselMonster]

When replacing epb, you have to follow a series of tests before all fault codes are clear. Also use a battery charger when testing EPB through VCDS and earlier modules didn't like users exiting the parking brake module on VCDS immediately, rather wait a few seconds. Follow this guide and it's associated pages:

VW Passat (3C) Brake Electronics - Ross-Tech Wiki (http://wiki.ross-tech.com/wiki/index.php/VW_Passat_(3C)_Brake_Electronics)

Have you done all the above in the link?

[Adrian1996]

Passat b5.5 2004- VIN is WVWZZZ3BZ5E114537
It was an abs module put in, that needs coded in
Steering angle sensor also needs coded as a result of new abs module, error code is g85 not matched

Can anyone help?

Need codes???

Thank you in advance