Coding using Foxwell NT500

[ChrisOOOO]

I have had a Foxwell NT500 for a while and only been using it for resetting service and winding off EPB, I know it has the capability to do coding but can’t find anything online as a guide how to do it as it brings up all the VCDS coding. Has anyone used this tool to do coding and can give me an idiots guide?

[ChrisOOOO]

I managed to figure it out and it’s pretty simple tbh. If anyone is interested I can take a few pics of how I done it and post them.

[Cp7hfu]

This might be a necropost, but it's this thread is only on the 2nd page of this section so hopefully that's OK!

I would appreciate if you could post the coding pics with your Foxwell Chris0000

Maybe I'm optimistic that this might bring the OP back to the forum after a little time away...

[ChrisOOOO]

Try looking at AudiEnthusiasts Home (https://www.audienthusiasts.com) in the VAG COM section. He has all the coding for an Audi A4 B8 but is similar for all platforms. If it’s specifically how to use foxwell your after I can upload a picture later.