PDA

View Full Version : Plenum Chamber



Q7quattro
16-01-2017, 10:13 PM
Has anyone cleaned their plenum chamber (s) ?

i would like to check mine get rid of debris / foliage if required and was looking for a "How To" (had a good look on Internet and this section of the Forum - but no luck)

thanks in advance

B5NUT
16-01-2017, 11:48 PM
I used a hover to start with then plenty of soap and water and various brushes, wheel, long reach etc..

Q7quattro
17-01-2017, 07:41 AM
I used a hover to start with then plenty of soap and water and various brushes, wheel, long reach etc..

Wouldn't be possible for you to describe / post a couple pics where the chambers are and how to access the.

many thanks

morski
17-01-2017, 12:41 PM
When you open the bonnet you will see a large plastic cover with vent holes on it at the bottom of the windscreen. Remove the rubber seal and lift the plastic up and towards the front of the car. Its just the passenger side where the air intake box is will be a bit awkward but does come out. Just make sure the seal sits correctly when you refit it all. No need to remove wipers etc