VW Touran 2011 ABS/ESP Light

[red1]

Hi All..

I had the dreaded ABS light come on the dash about a month a go... A scan with my trusty ELM 327 revealed a problem with my rear near side ABS sensor- I have since replaced both the sensor and the bearing hub.
Now when i scan i don't get the same error but the one attached..
Ross tech tells me below ....
However I'm not that experienced so even though i was able to replace bearing I don't have a clue where the module is situated or fed from?
Can any of you guys help me with an electrical diagram or a fuse panel layout? or maybe some things to check?
Really appreciate any help

ABS
Part #: 1K0907379BE
Component: ESP MK60EC1
Coding: 333B6016092806FACC1006ED901C6082310150 (hex)
Fault codes:
00668 Supply Voltage Terminal 30
03842 Manufacturer-specific code

Steering angle
[failed to connect]

Power steering
Part #: 1K0909144M
Component: EPS_ZFLS Kl. 70
Coding: [none]
Fault codes:
01316 ABS Control Module

Ross tech...
Possible Causes

Fuse(s) faulty
Wiring/Connectors from/to Control Module faulty
Power Supply (Battery/Generator) faulty

Possible Solutions

Check Fuse(s)
Check/Repair Wiring/Connectors from/to Control Module
Check Power Supply (Battery/Generator)

[niall campbell]

Can you check the voltage output of the alternator please, should be around 14.5 volts

Also check the battery for dud cell(s)


The car firstly checks the battery for power to make sure it has enough juice to work the brakes. Older cars and it checked at start up, before the alternator had a chance to charge the battery up& showed a fault in the ABS / ESP

Now it checks after around 8 minutes.

I also had similar problems and same faults as you by putting in a wrong alternator, sending my car haywire