anorak_ian
26-09-2015, 03:51 PM
Hi, Water temperature sensor and Mass air flow sensor replaced with genuine audi parts and Vag com still reports them as faulty.
Should I erase all errors in Vag com and start again?
The other thing,
"N122 Final output stage", this should be the connectors at the other end of the cables that come from the coil packs. I'm guessing it's a circuit board. Any idea where it is?
And:
There's a long strip of rubber where the cables go into, under the trim just in front of the battery, it says don't bend on it. Is this expensive? If this has been bent, would it stop the coil from working?
Should I erase all errors in Vag com and start again?
The other thing,
"N122 Final output stage", this should be the connectors at the other end of the cables that come from the coil packs. I'm guessing it's a circuit board. Any idea where it is?
And:
There's a long strip of rubber where the cables go into, under the trim just in front of the battery, it says don't bend on it. Is this expensive? If this has been bent, would it stop the coil from working?