xyz123
04-01-2015, 11:28 PM
Looking for a bit of advice.
My 57 Passat 1.9d s 56k, has a starting problem.
It starts then after about 1 sec stops and a message comes up "Engine fault see workshop". It starts after re inserting the key. This has happened about 8 times over the last 30 starts. It first happened after a cold spell.
I don't have access to a full scan but have used a Autel VAG Maxscan to read the codes, they are:
05658 Can bus
05659 Can bus
05660 Can Bus
05661 Can Bus
05488 Can bus
02811-046 Control Module for Electronic Steering Column Lock J764
I have done a bit of research on this site and Martins so am aware that this is quite common on Passats.
Am I correct in thinking that it's most likely to be the Steering Lock at the bottom of the column?
If this is the case ,it's a main dealer only job and costs about £300.
Regards Andy
My 57 Passat 1.9d s 56k, has a starting problem.
It starts then after about 1 sec stops and a message comes up "Engine fault see workshop". It starts after re inserting the key. This has happened about 8 times over the last 30 starts. It first happened after a cold spell.
I don't have access to a full scan but have used a Autel VAG Maxscan to read the codes, they are:
05658 Can bus
05659 Can bus
05660 Can Bus
05661 Can Bus
05488 Can bus
02811-046 Control Module for Electronic Steering Column Lock J764
I have done a bit of research on this site and Martins so am aware that this is quite common on Passats.
Am I correct in thinking that it's most likely to be the Steering Lock at the bottom of the column?
If this is the case ,it's a main dealer only job and costs about £300.
Regards Andy