Clauuualc
03-11-2014, 06:36 PM
Hello guys,
Got some very useful information from the forum so I decided to upload and describe the modifications I did so far to my car. Got a 2011 2.0tdi non-sline A6 and saw the picture from supersprint with the exhaust they developed for the 3.0 tdi.
I'm a student in Austria now and quickly got an V6 sline diffuser and the black mesh from ebay. This costed me around 160Euros (used diffuser, new mesh).
Everybody mentioned that the sline diffuser is gonna be a bolt-on replacement for the non-sline bumber. This was not the case as the sline one is slightly bigger than the other one and there is a small offset with respect to the fitment. After some bumper modifications, the diffuser was on. (another 80 euros to an audi dealer for the work).
Then I bought a set of 115mm (the supersprint ones are 100mm) round exhaust tips, angle cut. 50 euros
And I had manufactured a custom cat-back exhaust 60mm diameter. It goes just straight until the Y division (under the spare wheel) and then to the exhaust tips. They charged me 110Euros for that in Romania.
I sold my old exhaust for 130 euros.
So in the end, the whole project was 270 euros. A really low cost transformation.
I would appreciate some opinions. Now I'm looking for an S6 front bumper and a RS6 grill (without Quattro writing).
I've attached the photos of the supersprint one and mine before, during and after.
Got some very useful information from the forum so I decided to upload and describe the modifications I did so far to my car. Got a 2011 2.0tdi non-sline A6 and saw the picture from supersprint with the exhaust they developed for the 3.0 tdi.
I'm a student in Austria now and quickly got an V6 sline diffuser and the black mesh from ebay. This costed me around 160Euros (used diffuser, new mesh).
Everybody mentioned that the sline diffuser is gonna be a bolt-on replacement for the non-sline bumber. This was not the case as the sline one is slightly bigger than the other one and there is a small offset with respect to the fitment. After some bumper modifications, the diffuser was on. (another 80 euros to an audi dealer for the work).
Then I bought a set of 115mm (the supersprint ones are 100mm) round exhaust tips, angle cut. 50 euros
And I had manufactured a custom cat-back exhaust 60mm diameter. It goes just straight until the Y division (under the spare wheel) and then to the exhaust tips. They charged me 110Euros for that in Romania.
I sold my old exhaust for 130 euros.
So in the end, the whole project was 270 euros. A really low cost transformation.
I would appreciate some opinions. Now I'm looking for an S6 front bumper and a RS6 grill (without Quattro writing).
I've attached the photos of the supersprint one and mine before, during and after.