Help needed with Pure Highway 300di installation (Passat B6 2007 - RNS510)

[nick.king]

Afternoon all,

I was led to believe this was a pretty straight forward installation, and it probably is for some of you but I'm needing a bit of help.

I know where the cables go and how they connect up, but I have 2 issues.

1. Where to feed the additional cabling so it's hidden (so looking for help / guidance with that)?
2. Where to connect up the Positive Ignition 12V wire and how to do this?

The vehicle is a 2007 Passat B6 with a RNS510 installed, I've posted a few pictures of the Pure Highway kit to give you some idea what I've got. Any help and suggestions are very welcome, not sure if I should be removing the glove box (how do you do this?) to run the cabling to the RNS510, and where I should mount the main unit (it suggests in the glove box). If anyone has any guides on how to remove bits of the dash to run the cables that would be most welcome as well.

The manual for the Pure Highway 300di can be found here Downloads / In car (Highway) / Highway 300Di / Manual - PURE Help Centre

IMG_0426.jpg IMG_0427.jpg IMG_0428.jpg IMG_0444.jpg IMG_0445.jpg

Many thanks in advance.

Nick.

[nick.king]

I've sorted 99% of it out now, the only help I need is on where to connect up the 12V Positive Ignition wire?

Many thanks.

[nick.king]

Sorted, wired it up to the cigarette lighter in the front ashtray.

IMG_0478.jpg

Ran the USB cable in to the glove box and left the main unit behind the dashboard as there was plenty of room, obviously mounted the controller on the front of the dash. Working fine.