ABS Fault

**flange101** · 16-08-2019,08:30 PM

Hi folks just wondering if anyone can help with this fault... 00287 - ABS Wheel Speed Sensor; Rear Right (G44) 012 - Electrical Fault in Circuit

I have replaced the sensor and the complete hub stiil light is on..i cant seem to clear the fault with vcds the light just stays on wiring looks ok but i can only see so much of it as it goes up past the fuel filler into the car.. there is another fault but dont know if this has anything to do with it..this is in the module instruments...1 Fault Found:
00003 - Control Module
014 - Defective thanks for any help

**vag_tech** · 16-08-2019,10:04 PM

Volt drop in wiring. Most likely at connector.

**flange101** · 17-08-2019,09:03 AM

Thanks for the reply just wondering is it the connector at the wheel speed sensor or the abs control connector in the engine bay..

**Ste1981** · 17-08-2019,10:39 AM

Did you fit a genuine sensor these eBay ones are a waste of time

**flange101** · 17-08-2019,08:40 PM

Hi thanks for the reply yes its a genuine sensor had it on vcds today measuring block all sensors working but the rear right is dead or closed its starting to do my head in now just dont know where to start..need it of for m.o.t its my daughters car not long past her test just a runaround till she gets a year or so on the road..cheers mate.

**Crasher** · 18-08-2019,04:41 PM

You need to pin to pin check the wiring to the sensor at the ECU plug using a multimeter, I will look the PIN numbers up for you tomorrow if you remind me.

**flange101** · 18-08-2019,09:43 PM

Originally Posted by Crasher

You need to pin to pin check the wiring to the sensor at the ECU plug using a multimeter, I will look the PIN numbers up for you tomorrow if you remind me.

. Cheers mate that would be very helpful.