Re: wiring help please –
09-01-2017,02:00 PM
You are going to struggle to fit the complete loom up to the point of the crimped pins. If you know where the damage has been done to the old loom i suggest you cut it there and solder this new loom on and only the section you need. Heat shrink each joint and then wrap the repaired section in self-amalgamating tape to prevent water ingress.
Audi's official way of repairing cables is to crimp and not solder but ive seen corrosion ingress in this so solder/shrinkwrap is better than crimp.
RS6 Performance Ascari Blue, Carbon Ceramics Brakes and lots more.
A6 BiTdi Avant MTM
Retrofitted: Full Led Headlights, DAB, Full Electric Seats, Surround View Cameras, Genuine RS6 Grille, RS6 Seats,Leather Door Armrests, Soft Close Doors, Rear Side Blinds,High Beam Assist, Eibach Springs, Led Roof Console, 4 Zone Climate, Rear Heated Seats, Head Up Display, Side assist, Alcantara Interior Retrim