TV Tuner - Retrofit

[dghdgh]

When install the rear camera you can get the lead under the roof lining to the front but takes a little bit of jiggling with a cable rod.

Looks all complex!! ?

Bought these today for future use

Silverline plastic 5 piece Car Trim Remover Set -

NOT sure what yet though..

1st project will be charging lead for dash cam... Top winning contenders for dashc am remain to be the ever popular FPV Möbius Action cam hopefully back and front..





Sent from my LG-H961N using Tapatalk

[satyp]

When install the rear camera you can get the lead under the roof lining to the front but takes a little bit of jiggling with a cable rod.

Middle of the roof lining or along the side .. should hopefully be the same with rod di you think?...

Sent from my LG-H961N using Tapatalk

[dghdgh]

I went down the passenger side from back to front, took 2 people one jiggling and one easing the roof lining down at the front and hooking the rod end. You need solid cable rods as the flexible coils just go round in circles. If you catch my post re using a breakout fuse from the ns footwell fused box.
Sorry for hijacking the thread Andy.

[andyhud007]

I went down the passenger side from back to front, took 2 people one jiggling and one easing the roof lining down at the front and hooking the rod end. You need solid cable rods as the flexible coils just go round in circles. If you catch my post re using a breakout fuse from the ns footwell fused box.
Sorry for hijacking the thread Andy.

No worries. All good info!

[inchshort]

Well it would have been rude not to get this mod done by Andy whilst getting the soft door mod and dimming mirrors done!

great job with this as usual by Andy.

[Davus]

Nope...he just did it while doing a general software update.

There are about 8-10 separate parts you need for this. TV Tuner itself, bracket, nuts, amplifiers, repair wires etc. Its not just a single item unfortunately..

The TV Tuner itself is: 8V0 919 191 C (or above)

Cheers

Andy

Hi Andy,

Im in Australia so its a little difficult for me to engage you directly to do thei retrofit. Would it be possible at all for you to outline the part numbers needed for this retrofit, and the process you followed? Im keen to undertake this also.

Sorry - i know this is a super old thread, so hopefully youre still around!.

Dave

[ShadowM81]

Nope...he just did it while doing a general software update.

There are about 8-10 separate parts you need for this. TV Tuner itself, bracket, nuts, amplifiers, repair wires etc. Its not just a single item unfortunately..

The TV Tuner itself is: 8V0 919 191 C (or above)

Cheers

Andy

Hi Andy,
pls send me part number on amplifiers.
Thanks