Hi all, I have a 1998 Audi A4 Avant 2.8 V6 Quattro with the ACK engine. Since purchasing it I have had an intermittent problem with the ABS warning bulb coming on usually when I've either hit around 80mph or been on quite a long run in it. I wasn't getting the warning beeps until recently and now I get them and the warning light every time I start the engine.
I recently purchased a diagnostic cable and used Vag-Com on it, returning this error -
VAG-COM Version: Release 409.1-US
Control Module Part Number: 8E0 614 111 A
Component and/or Version: ABS/EDS 5.3 QUATTRO D00
Software Coding: 0273004284
Work Shop Code: BB 24334
1 Fault Found:
01203 - Electrical Connection between ABS and Instrument Cluster
03-10 - No Signal - Intermittent
Does anyone have any idea what this error means? I have run it through Vagalizer and it says the following -
01203 - Electrical Connection between ABS and Instrument Cluster
01203 - Electrical Connection between ABS and Instrument Cluster: Open or Short to Ground
Possible Symptoms
- ABS Malfunctions
Possible Causes
- Wiring between ABS and Instrument Cluster defective
- Instrument Cluster defective (rare)
Possible Solutions
- Check Wiring between ABS and Instrument Cluster for Short to Ground/Open Circuit
- Check Instrument Cluster
01203 - Electrical Connection between ABS and Instrument Cluster: No Signal
Possible Symptoms
- ABS Malfunctions
Possible Causes
- Wiring between ABS and Instrument Cluster defective
- ABS incorrectly coded
- Instrument Cluster defective (rare)
Possible Solutions
- Check Wiring between ABS and Instrument Cluster for Short to Plus
- Check ABS Coding
- Check Instrument Cluster
But I cannot believe it would be the wiring between the ABS system and the instrument cluseter so if anyone has any ideas on this it would be greatly appreciated.
Many thanks