a.gilbert
27-11-2009, 12:16 PM
how to remove and replace temp.gauge sender unit
With a cold engine, remove the rad cap to release the pressue,replace rad cap.unclip the loom connector
Remove the curclip holding the sensor, remove the sensor make sure the "O" ring is removed.
Place "O" ring on new sensor,putnew sensor in, replace curclip, re-connect the loom.
leon_richard
09-12-2009, 11:46 PM
How did it go? was yours pointing downwards?
Powered by vBulletin® Version 4.2.4 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.