Vag Com codes

[pg20]

Just managed to get vagcom to work and wondered if anybody could shed some light on the messages / codes that came up?

VAG-COM Version: Release 311.2-N


Chassis Type: 8D - Audi A4 B5
Scan: 01,02,03,08,15,17,25,35,45,55,56

Address 01 -------------------------------------------------------
Controller: 028 906 021 CE
Component: 1.9l R4 EDC 00SG 0803
Coding: 00002
Shop #: WSC 06187
3 Faults Found:
00519 - Intake Manifold Pressure Sensor (G71)
28-00 - Short to B+
00513 - Shareware Version. To Decode all DTCs
03-10 - Please Register/Activate - Intermittent
17978 - Shareware Version. To Decode all DTCs
P1570 - 35-10 - Please Register/Activate - Intermittent
Readiness: N/A

[Alan02]

The Address Code relates to the Number that VW have given that particular ECU.ie: 01=Engine Electrics.
Controller is the Part Number of the interogated ECU.
Component is the item in question ie: 1.9 EDC(electronic diesel control),and reference number.
Coding is what spec. its coded to depending on vehicle.
Shop is the Diagnostic Computer which coded the ECU.
The fault codes are listed next,alongside a breif description.
Readiness relates to wether the vehicle has completed a `full driving cycle `to determine if everything is in order,basically a `Self Check`.
Hope this clears a few things up for you.

[pg20]

Thanks for the reply. Was rather hoping somebody could tell me what the fault codes mean?

[Alan02]

Oh,well at least it was a typing excercise for me then.

[pg20]

Sorry, didn't mean to sound ungrateful. Thanks for your help :-)

[kite]

Check the codes on the wiki

http://wiki.ross-tech.com/index.php/Main_Page

[Alan02]

Sorry, didn't mean to sound ungrateful. Thanks for your help :-)

No,i didnt take your comment the wrong way! Me goin over the top more like,and not answering wot was asked!! LOL

[Crasher]

00519 Intake manifold pressure sender -G71. Short to positive

1) Open circuit or short circuit
2) G71 defective

= Loss of power > Check intake manifold pressure sender

00513 Engine speed sender -G28

a) Implausible signal
i) Sensor disc bent or loose
ii) G28 defective
iii) Open circuit in screening

b) No signal
i) G28 defective
ii) Open circuit or short circuit

1) Engine will not start
2) Engine cuts out
3) Glow plug warning lamp flashes

Remove oil sump and check sensor disc
Check engine speed sensor

17978 Engine control unit disabled

1) Attempted tampering
2) Immobiliser not adapted
3) Immobiliser defective

Engine starts but cuts out again immediately

Scan immobiliser
Adapt electronic immobiliser to engine control unit