View Full Version : engine workshop! but no codes
estate130
19-04-2009, 07:55 PM
hi there
i have a 2005mk4 tdi130 which today displayed the engine workshop msg & has the flashing pre-heat lamp continuously.
i put my code code reader on but no codes were stored. the cruise control has stopped working however.
could this be a brake pedal switch related problem??
any thoughts appreciated!
stephen k
19-04-2009, 08:40 PM
faulty brake pedal switch definitely causes these warning lights to light up.
had this with mine - but I did get a code (16955) with my code reader
good news was a replacement switch was £5 and relatively easy to fit
estate130
20-04-2009, 10:53 PM
thanks - i have a replacement switch so may change to see if this clears the fault.
i'm concerned by the absence of any code, does any one else have similar experience -- no code but MIL flashing?? :1zhelp:
thanks
talesy
21-04-2009, 10:12 AM
I had the same problem, where I replaced the brake light switch, still no fix. I could have kicked myself! The previous week I changed the brake light bulb but put in a single element type instead of a dual element. This was the problem. What a D******d!
Regards
Talesy:o
zollaf
21-04-2009, 10:17 AM
if you are using an obd only code reader, then this wont show manufacturers only faults, only obd faults.
estate130
21-04-2009, 11:45 AM
Thanks - i will check all these other things. i think my code reader does all protocols but will double check
Cheers
Powered by vBulletin® Version 4.2.4 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.