PDA

View Full Version : 51 plate polo wiring diagram for AIR central locking



unclespevie
10-03-2009, 02:04 PM
Hi all, newbie here...

i just been searching for answers to the dreaded upgrade to remote central locking from standard central locking.

i too bought a kit ( it has 12 wires in a block to connect to RCL module) but question is, can i fit it to the wiring loom in the boot where the air compressor is or does it have to be connected to the drivers door actuator. Noww seen comments about adding a resistor in there but still unclear.

now my kit tells me not to touch the Lock/Unlock wires but to splice the COMMON WIRE ( this is the 12v + wire i presume) but looking at the connector block in the boot for the air compressor it has 2 common wires that are RED/WHITE....

I can post a picture of the installation instructions picture for someone to comment on, at this moment not sure if its a direct fit or need summat like resistor adding...

Any info a godsend.

Kevin

PS, will check for any posts later this evening and will update this post with diagram.

unclespevie
13-03-2009, 04:38 PM
here is the link to the fitting instructions, i presume i use the bottom one but its not very clear as it doesnt say splice into the lock/unlock wires..

http://s699.photobucket.com/albums/vv359/unclespevie/?action=view&current=img006.jpg#


http://s699.photobucket.com/albums/vv359/unclespevie/?action=view&current=img006.jpg