Mike McKinstry
20-05-2008, 12:43 PM
Hi,
01 130pd passat-I have changed the MAP sensor this week to cure intermittent limp-17965 charge pressure control-positive deviation P1557 -35-00.
When looking into the loom side of the connector for this sensor the blue or green(cant remember)plastic/rubber seal only appears to wraparoud three sides of the pin connectors-is this right or have I lost some seal .I disconnected this and changed part without it logging a fault so if someone could look to see if theirs is same I would much appreciate it.
The map cahnge was to cure overboost sticking at 2983 mb however this has not sorted problem.
Regards,
Mike
01 130pd passat-I have changed the MAP sensor this week to cure intermittent limp-17965 charge pressure control-positive deviation P1557 -35-00.
When looking into the loom side of the connector for this sensor the blue or green(cant remember)plastic/rubber seal only appears to wraparoud three sides of the pin connectors-is this right or have I lost some seal .I disconnected this and changed part without it logging a fault so if someone could look to see if theirs is same I would much appreciate it.
The map cahnge was to cure overboost sticking at 2983 mb however this has not sorted problem.
Regards,
Mike