Passenger Airbag Deactivation Fault

[jluckcuck]

I've recently replaced both seatbelt tensioners, driver airbag and passenger airbag, had my airbag modules crash data erased, but the airbag light keeps coming on (even when I reset it with my CAN OBD reader). When I erase it, the light goes off, but then comes bck on a second later. I get a fault code "01578" which means "Airbag Deactivation Warning Lamp: Passender Side (K145)".

I can activate and deactivate the passenger airbag from within the glovebox, but this doesn't seem to be the issues. I'm wondering when I fitted the airbag whether there's something I should have done with the new airbag like pull a pin out or enable it somehow? I literaly just plugged the new one straight in. Did I miss something?

[kenney]

Hi Your code means one of the following faults Open circuit
Short to earth or short to positive
Warning lamp -K145 defective
Control unit for airbag -J234 defective

[jluckcuck]

All sorted. I'd not connected the 2-pin wire that plugs underneath the front of the radio / navigation unit where the passenger airbag deactivation light was.