lpg boy
20-04-2008, 10:11 PM
have genuine Key Com Ross Tech cable e.t.c. for about 2 years now but it won't 'open controller' on either my B4 or B5.5 passat ,even though it had no problem in the past , engine, abs electrical etc.
Thought laptop glitch has upset how it was communicating so did a port setup test to check - following was displayed in an overpage:
port status o.k.
interface found
type ross-tech key-com v3.01
status questionable
K1 short to ground
K2 short to ground
CAN not supported
the dongle does not have a fuse in, just a board of electronics.
I did try and read a corrado which it wouldn't but later found it had been 'chipped'. Could this have upset something ,if so what is the cure?
Thought laptop glitch has upset how it was communicating so did a port setup test to check - following was displayed in an overpage:
port status o.k.
interface found
type ross-tech key-com v3.01
status questionable
K1 short to ground
K2 short to ground
CAN not supported
the dongle does not have a fuse in, just a board of electronics.
I did try and read a corrado which it wouldn't but later found it had been 'chipped'. Could this have upset something ,if so what is the cure?