gregbolshaw
06-04-2008, 12:49 AM
Following an intermittent problem with the central locking, I have removed the door locks to clean and grease them. Since removing the retaining Torx-15 screw and door lock on the passenger door, the door handle no longer sits flush to the car - it is raised by approximately 5mm from it's normal position. I have tried adjusting the door release cable which is connected to the handle, but I can't get the handle back to it's original position. The handle is fine on the drivers side, after removing/refitting the lock.
Any ideas what could be causing this? How is the door handle removed?
Thanks
Greg
Any ideas what could be causing this? How is the door handle removed?
Thanks
Greg