PDA

View Full Version : VENTO 1995 WHEEL BEARINGS



FINDAD
06-12-2006, 09:39 PM
Hi, can anyone tell me (a novice) how dfifficult is it to change the rear bearings on my Vento plse? Thanks:Blush2:

thefoolmccool
07-12-2006, 09:16 AM
It is very easy if you have drum brakes at the back. Basically, Take the cover off th ehub in the middle of the wheel. Loosen the large bolt behind this. Jack the car up. Remove wheel and then wriggle the drum off the shoes. Th ebearings should fall out. You must also replace the bearing collars which should be pressed out, but can be remove using a punch (carefully). To put the new collars in, use th eold ones to hammer them in. Not bad, to do 1 takes about 1/2 hour.

Kev