PDA

View Full Version : Washer Jets



Moro Anis
23-03-2008, 10:24 PM
My screen washers seem too low. They hit the bottom of the screen and get masked by the wipers. I looked at them for adjustment but they seem llike a moulded plastic assembly. Is there any adjustment or are they designed into that position?

bazzill
26-03-2008, 11:08 PM
you tried poking some sort of pin into them and see if you can move the bit inside up a bit? worked on my other car...

ryanant
20-04-2008, 06:41 PM
now you have mentioned it the spray on my car is too low as well, i will try the pin trick later but it should do the job!

Moro Anis
21-04-2008, 01:45 PM
Since I first posted, I've investigated further and there's more to it than that. If you look at the bottom of the jet (against the bulkhead) you will see a screwdriver slot. This is an eccentric cam. Rotating this alters the height and aim of the jet, however I've adjusted mine to aim high and it still hits the arm and sprays low. I think the hole in the jet is a moulding and non adjustable, hence the cam.