dulux72
08-08-2018, 09:43 PM
Im looking for some help in retro fitting a rear view camera to a 2017 Sportback
I've replaced the original trunk handle and routed the cables but the only wiring instructions I was supplied are as follows
Blue 12 PIN Quadlock Connector 035 447
Cable No1 - Pin no.12
Cable No2 - Pin no. 6
Orange Cable - CAN High
Brown Cable - CAN Low
Red Cable - +12v
Black Cable - GND
I've found all the other points except the CAN high and CAN low
As these come with spades to insert into connectors I'm guessing that there a space in an existing block for these
Somewhere in the rear trunk / boot
Any help gratefully recieved
I have full VCDS so am able to code the camera once the cabling is sorted
Thanks in advance
I've replaced the original trunk handle and routed the cables but the only wiring instructions I was supplied are as follows
Blue 12 PIN Quadlock Connector 035 447
Cable No1 - Pin no.12
Cable No2 - Pin no. 6
Orange Cable - CAN High
Brown Cable - CAN Low
Red Cable - +12v
Black Cable - GND
I've found all the other points except the CAN high and CAN low
As these come with spades to insert into connectors I'm guessing that there a space in an existing block for these
Somewhere in the rear trunk / boot
Any help gratefully recieved
I have full VCDS so am able to code the camera once the cabling is sorted
Thanks in advance