View Full Version : Which drive bit do I need for these brake pipe clips?
mikeote
25-06-2017, 07:11 PM
Hey guys,
Can you tell me which drive bit I need for these brake pipe clips? Eight point security ribe ??? =/ Any one know where I can get one?
33411 33412
Cheers
Mike
zollaf
25-06-2017, 09:42 PM
think they just unscrew. they are on like a bolt that welded to the axle, just remove the brake pipes and unscrew the clip, probably.
mikeote
26-06-2017, 10:40 AM
Ok that's a relief, I'll try once the replacement brake pipe arrives. Here's hoping that the rear brake pipe terminals are not rusted together! =/
Thanks Zollaf!
Crasher
26-06-2017, 11:22 AM
They are as Zolly says a welded stud. If they break off, replacing them is difficult, the repair pop rivet versions are £7each.
Powered by vBulletin® Version 4.2.4 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.