3G PDC Module Question

[dan2485]

I have retrofitted an OEM PDC module to my car, but i cannot get the park assist to show in the MMI.

The module is showing no faults.

Address 76: Park Assist Labels: 4Fx-910-283.lbl
Part No SW: 4L0 910 283 B HW: 4L0 919 283 B
Component: Parkhilfe 4-Kan H02 0500
Revision: 00H02000 Serial number: 12331003200489
Coding: 0200006
Shop #: WSC 02324 785 00200
VCID: 29591CB680D4A369191-807C


No fault code found.

I have added the module to the gateway installation list and then reset the MMI but it wont show on the MMI in the Car page.

Do I have to change a setting in the hidden menu?

This is the correct module and it is capable of the graphical display, anyone got any tips.

[Guest 2]

Should only be coding within that controller.

Coding seems to be correct.

[B5NUT]

Yes you need to go into the hidden menu of the 5F module and add PDC.

[dan2485]

Do you know the setting?

is a vcds coding thing or a change in the green menu?

[B5NUT]

It could be in coding, but check in /main/car/carmenuoperation & /main/car/cardevicelist

[dan2485]

You are correct you do have to change a setting in the Green Hidden Menu and you have to change the coding in the 5F controller.

I will update this thread in the morning with the settings.

Thanks again all is good now.

[dan2485]

After installing the Controller, Bumper with PDC’s and the wiring the following needs to be done.

1. Using VCDS open the ‘19’ Can Gateway controller and select the installing list.

2. Check the ‘76’ Park Assist check box and save the settings (this will change the controller coding).

3. Open the ‘76’ Park assist controller and change the coding by changing the second 0 to 2. ( the coding is explained here http://www.audi-portal.com/en/diagnostic/ecu_11910.html#1)

4. Now click the ‘Do it Now’ box.

5. Now open the ‘5F’ Central Electronics controller and select coding.

6. Now select the long coding helper and click on Byte 8.

7. Now Check the Park Assist check box and close the helper box.

8. Now click the ‘Do it Now’ box.

9. Now you need to access the Hidden menu and select Car then CarMenuOperation.

10. Scroll to Parking Help and press select (BIG KNOB on the MMI) and scroll the setting to 5.

11. Now Press select (BIG KNOB on the MMI) and exit the menu press Radio Button.

12. Now you need to reset the MMI (press SETUP, BIG KNOB and top right soft button together).

You Should have the Parking assist in the MMI.