PDA

View Full Version : Question Cruise retrofit



roadiescot
31-05-2014, 08:23 PM
Bought the stalks and cowl from the local dealer and he confirmed they were "right" for my car using the reg number.

Fitted them this evening easily, enable the check marks in the ECU (01) and Steering module (16) but it seems it will not switch on.

Did a scan and got this

Address 16: Steering wheel Labels: 8K0-953-568.clb
Control Module Part Number: 8K0 953 568 F HW: 8K0 953 568 F
Component and/or Version: Lenks.Modul H11 0012
Software Coding: 000016
Work Shop Code: WSC 06325 000 00000
VCID: 3D71D2B9A40937F6B01-8068
1 Fault Found:

01044 - Control Module Incorrectly Coded
000 - - - Intermittent
Freeze Frame:
Fault Status: 00100000
Fault Priority: 3
Fault Frequency: 1
Reset counter: 113
Mileage: 83404 km
Time Indication: 0
Date: 2007.10.26
Time: 00:09:03

date and time had not been reset after connecting the battery.

Any idea anyone???

Guest 2
31-05-2014, 08:24 PM
Did you clear the fault and go for a drive?

It only enables 19+mph, make sure your vcds is also up to date.

roadiescot
31-05-2014, 10:13 PM
using the latest VCDS. Went out once laptop had some more charge and tinkered. Got into the settings and could see all the switch values coming through. old see the preset values for the cruise on the dash so looking good.

Had had a beer so didn't go out. Will try in morning

Update: works a treat