coyoteboy
27-01-2013, 08:37 PM
I'm trying to find a clutch that fits my flywheel and gearbox - the flywheel is the 034 motorsport v8 insert which supposedly uses the clutch from the URS4/S6 and works with the o1e gearbox, but when I search for clutches for that car it usually comes up with a friction disc spline size of about 20.4mm (24 tooth). This isn't the same as the 01E input shaft (23.something mm diameter, 24 tooth spline).
I started hunting for other 240mm clutches in the range that could hold the torque of an ABZ, and would fit the same flywheel arrangement as that found on my flywheel insert, while having the correct spline.
Obviously I could buy a 240mm spring plate from the 2.2T I5 engine to match the flywheel, then track down a friction disc from any car with an 01E, but then I'm a bit stuck if they have any incompatibilities.
Any advice would help here, if anyone can think of a suitable clutch, or point me to a reasonably priced source of clutch parts who might help me filter out the possibilities.
I started hunting for other 240mm clutches in the range that could hold the torque of an ABZ, and would fit the same flywheel arrangement as that found on my flywheel insert, while having the correct spline.
Obviously I could buy a 240mm spring plate from the 2.2T I5 engine to match the flywheel, then track down a friction disc from any car with an 01E, but then I'm a bit stuck if they have any incompatibilities.
Any advice would help here, if anyone can think of a suitable clutch, or point me to a reasonably priced source of clutch parts who might help me filter out the possibilities.