Cruise control retrofit help needed

[s7gpt]

Ok ive now sourced the parts but need some instructions to fit it. Im aware i will it will need coding after but will cross that bridge once ive installed it.

Please some one help with instructions to fit, ive searched high and low but cant find any :1zhelp::1zhelp::1zhelp:

ps its an A4 b8 model with mutl function wheel and mmi 2g high ;)

A6 Chris and anyone else who read my earlier post, sorry im such an idiot i guess its with all the stress of buying my new car that i posted wrongly, would remove but no idea how :Blush2:

[Guest 2]

Battery negative off - drivers airbag off - steering wheel off - steering trim off - slip ring off* - steering angle sensor off* - steering ecu out - switch pack off - new switch pack on then the reverse of what you've done.

And coded with vcds - don't start until you know you can get it coded

*cant remember order of those two



Sent from my iPhone using Tapatalk

[sacha35]

Hear you go, I suggest you copy these pages to your desktopand print them off.

Hope this helps.

Paul


<removed see below>

[Guest 2]

Hear you go, I suggest you copy these pages to your desktopand print them off.

Hope this helps.

Paul


<removed see below>

We cant have these displayed on the forum due to copyright.

[s7gpt]

thanks all, any chance i could have them emailed to me Sacha35, g.tinsdale@sky.com

[Guest 2]

thanks all

thanks and like buttons are at the bottom left of each post ;)

[s7gpt]

Cheers ;)

[sacha35]

We cant have these displayed on the forum due to copyright.

SorryA6_ Chris. it wont happen again.

[chrisroff]

Hi,
I've just fitted cruise control to my A4 B8 2.0TDI. I've had it coded and its working fine but now my multifunction buttons don't work on the steering wheel. The VCDS is coming up with this:
1 Fault Found:
02071 - Local Databus
012 - Electrical Fault in Circuit
Freeze Frame:
Fault Status: 01101100
Fault Priority: 3
Fault Frequency: 1
Reset Counter: 218
Mileage: 157670 km
Time Indication: 0
Date: 2013.08.03
Time: 18:32:17

Does anyone have any pointers? It was fine before I fitted the new stalk assembly. Any help much appreciated.

Thanks