96 A4 Drivers Seat Removal

[MIDCO]

HELLO EVERY ONE
ANY BODY KNOW HOW TO GET DRIVERS SEAT OUT OF A 96 A4 1.9TDI TO FIT A BUSH ON SEAT SLIDE
:aargh4::aargh4:

[Gizmo68]

Providing its the same as most of the rest in the VAG range then:

1. Slide the seat as far forward as possible,
2. undo the two torx screws in the plastic trim on the seat rails (the torx is under a plastic cap)
3. Slide seat back as far as possible
4. Undo the two 13mm nuts on the front center of the seat
5. Push seat back a couple of inches out of the mounting plate on the floor.
6. Lift the front of the seat up approx 10" and unplug all of the plugs going to the seat.
7. Push seat back, out of the rails and lift out.

When you put the seat back in make sure the battery has been disconnected for at least 30 mins before you plug the airbag plug (yellow one) back in!!