PDA

View Full Version : RearNumber plate screw help



Mr Tibbs
15-01-2012, 01:20 PM
Please can someone confirm the screw size needed for the rear plates? I am a total noob and need to know the size and type of screw if i went to a UK hardware store. Audi garage is too far to drive.

I am 100% screwing them in so other options are not an option.

I am not going to Audi for them so if i was going to a normal hardware store what would i ask for?

Thanks!

hibbsy21
15-01-2012, 01:42 PM
Wrong section, but you could just use a normal screw that fits the hole, a bit of trial and error required. Alternatively, you could get some silicon, seal up the holes and use some 3M double sided foam tape and stick it one with that. I did this about a year ago and even pulling the plate it wont come off. And it looks nicer with no holes on the plate. ;)

But yes, wrong section. Please administer a sharp slap to the wrist, before Esh does! :p

Rich