PDA

View Full Version : 1.9 tdi 1z running problem



bryant25
19-11-2010, 08:49 PM
recently had a starting problem on my t25 fitted with 1.9 1z engine . I changed the stop solenoid ( power supply good ) and proved the fuel supply and return were sound . Still not starting , i then ventured into the fuel pump and removed the cover of the actuator and noticed the actuator arm was jerking about (with the ign switched on ) . I then found a bad earth quite by accident and when this was corrected the engine started no problem . Hey presto i thought . 2 days later i set off and had just got round the corner and the engine reverted to a very slow idle . I have cleaned the ecu terminals within and the connector plug is clean yet the ecu doesn't seem to be giving the actuator a signal to put fuel on ( i have tried the actuator with a 12v transformer and it does move proportionally to the voltage ) . The engine will start on easy start but will only run on tick over . Could someone inform me what faults would keep the fuel signal off .
Many thanks . Bryan.

http://www.vwaudiforum.co.uk/forum/applied/misc/progress.gif